|the difference between Hot Runner and Cold Runner|
Molds with hot runner or valve gate systems will simplify end-of-arm-tooling (EOAT) design and reduce cost by eliminating runner grippers or vacuum cups and allow for faster part removal. If a mold must have a cold runner,
try to sub-gate the parts from the runner and have round pads for vacuum removal, this will eliminate the need for a post mold degating device and save cycle time for other operations. Vacuum runner removal is faster, lighter and less expensive when compared to pneumatic grippers.
When the mold cannot have sub-gated parts a degating station will be needed. A degating station can be as simple as a pneumatic nipper mounted on the robot traverse beam to a sophisticated floor-mounted station with guillotine style shears to cut long fan gates. A simple degating station with two to four nippers can cost as little as $5,000 to $7,000.
About First-rate Mold Solution Co. Ltd.